HARLEY DAVIDSON DYNA FLOORBOARD KIT INSTALLATION MANUAL
download Installation SHIFTER ASSEMBLY (LEFT SIDE) 1. Remove highway footrest assembly, if equipped. Discard bracket, plate and mounting hardware. 2. Remove stock footrest assembly. 3. Remove stock...
View ArticleDucati Sport Clutch Lever INSTALLATION INSTRUCTIONS
download 1 To remove your stock lever, use a 19mm wrench or (adjustable wrench) to remove the large sheet metal nut attached to the main pivot bolt that holds the lever. (Photo 1a) Once the locknut is...
View Article1951 AJS MAINTENANCE MANUAL AND INSTRUCTION BOOK
download Throttle twist grip. On right handlebar. Twist inwards to open. When fully closed engine should just idle when hot. Air lever. Small lever on right handlebar. Pull inwards to increase air...
View ArticleHARLEY DAVIDSON XL HAND LEVER INSTALLATION INSTRUCTIONS
download These kits fit all 2004 and later XL Sportster® model motorcy- BRAKE LEVER INSTALLATION Removing the Brake Lever Do not remove or install the master cylinder assembly without first positioning...
View Article1954 AJS MAINTENANCE MANUAL INSTRUCTION BOOK
download Throttle twist grip. On right handlebar. Twist Inwards to open. When fully closed engine should just idle when hot. Air lever. Small lever on right handlebar Pull Inwards to Increase air...
View ArticleHARLEY DAVIDSON HAND CONTROL LEVER KITS INSTALLATION INSTRUCTIONS
download INSTALLATION The rider’s safety depends upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Dav-...
View Articleharley- davidson DYNA BLACK FORWARD CONTROL KIT installation Manual
download 1. Disconnect battery cable, negative (-) cable first. 2. Remove the left side rider footrest assembly. Save the footrest and fasteners for installation. Discard the remaining hardware. 3....
View Article2007 Ural Models Gear Up Patrol Tourist Installation Manual
download Font Brake Control Lever Clutch control lever: When the clutch lever is squeezed, the engine is disengaged from the gearbox. When the lever is released, the engine and gearbox are engaged....
View ArticleHARLEY DAVIDSON HAND LEVER KITS INSTALLATION MANUAL
download BRAKE LEVER INSTALLATION Do not remove or install the master cylinder assembly without first positioning a 5/32-inch (4 mm) thick insert between the brake lever and lever bracket. Removing or...
View ArticleHARLEY DAVIDSON CUSTOM HAND LEVER KIT BRAKE LEVER INSTALLATION
download 1. See Figure 1. Squeeze the brake lever and place the cardboard insert between the brake lever and lever bracket. NOTE Use the eyelet of an ordinary cable strap if the cardboard insert is not...
View Article
